Regenerative Dryers

Regenerative Dryers Line

The Pneumatech innovative desiccant dryers give customers efficient protection against the presence of any humidity in the air, which often is the source of corrosion, decreased efficiency of equipment/tools, and freezing of water in pipes. A desiccant or adsorption dryer uses desiccant material to adsorb and remove the humidity from compressed air. With this method, a pressure dew point as low as -70°C/-100 °F can be reached. A desiccant dryer should be used when the ambient temperature goes below freezing point, to avoid ice forming in pipes and applications.

Extruded Heatless – PH HE Series

Incorporating high-quality components, PH heatless adsorption dryers provide you with clean, dry air to extend the life of your equipment and products. Heatless adsorption dryers use dry, expanded purge air to remove moisture from the desiccant material.

  • Advanced energy management for lowest operating costs
  • High-quality, high-efficient desiccant
  • Spring-loaded cartridges
  • Counter-current regeneration for optimal energy efficiency
  • Designed for transportability & mountability
  • Low noise levels
  • High reliability and robust design

Brochure Links

Externally Heated – PE Series

With distinctive, patented technological innovations and energy savings capabilities, Pneumatech’s PE heated desiccant dryers provide efficient solutions to meet the needs of any customer application.

  • Purelogic advanced control with remote start/stop and web monitoring standard on all models
  • Galvanized piping with flanged connections
  • Quality butterfly and check valves with SST discs
  • Thermostatically controller, low wattage heating element

Brochure Links

Welded Heatless – PH Series

Incorporating high-quality components, PH heatless desiccant dryers provide you with clean, dry air to extend the life of your equipment and products. Heatless desiccant dryers use the compressed air to remove any moisture from the desiccant material.

  • Purelogic controller featuring Cycle Sight shows cycle time and tower status (only on HE versions)
  • High-quality, 2-way pilot-operated inlet switching valves
  • Free contact to link dryer operation to compressor load cycles
  • Adjustable purge control
  • Status memory to resume operation where dryer left off

Brochure Links

Blower Purge – PB Series

Delivering superior performance and durability, along with exceptional dryer power, Pneumatech’s blower purge dryers add extra value to your operation by conserving compressed air and extending desiccant life.

  • Purelogic advanced control with remote start/stop and web monitoring standard on all models
  • Quality butterfly and check valves with SST discs
  • Low KW centrifugal blower with safety alarm
  • Tower switching based on real-time dewpoint
  • Galvanized piping with flanged connections

Brochure Links

Zero Purge – PB Series

Operating costs are reduced to the absolute minimum thanks to PDP control, regeneration & cooling temperature control and compressor synchronization; which are all integrated in the Purelogic controller. Zero Purge variants are equipped with a purge back-up mode which switches the dryer to purge cooling mode in case PDP could not be met at ambient conditions outside of limitations.

  • Purelogic advanced control with remote start/stop and web monitoring standard on all models
  • Advanced energy management for lowest operating costs
  • Counter-current regeneration for optimal energy efficiency and guaranteed dry air
  • High efficient heaters
  • Compact and efficient side-channel centrifugal blower

Winnipeg

# 9, 1201 Grassmere Rd
West St Paul, MB, R4A 1C4
Phone: 204-237-4247
Toll Free: 877-323-7247
winnipeg@cfmair.com

Contact Us